Supacolor Promotional Transfer

How to Press Cotton Bags Like a Supastar

1

Set Temperature and Time

  • 320F (160C)
  • 12 seconds

2

Load a Test Bag

If possible, slip the platen through the bag so there is only one layer of fabric on top. Otherwise lay bag on top of the platen. Avoid seams and gussets if possible.

3

Set Pressure

  • Manual Press: Tighten dial until the press won’t close. Loosen dial progressively until the press closes, use less pressure for polyester.
  • Hotronix and Geo Knight: 8-9
  • Pneumatic Press: 40-50 PSI

4

Pre Press: 5-8 Seconds

Pre pressing releases moisture from the bag, ensuring good contact. Repeat this step until there is no steam.

5

Place Supacolor

Position the transfer on the bag. Lay teflon sheet or parchment paper over the Supacolor.

6

Press 12 Seconds

7

Peel Immediately

Hot peel immediately from a corner in one smooth motion. Peel with confidence and without hesitation. Hold down bag with your free hand for better control.

8

Post-Press: 2 Seconds

Use a teflon sheet or parchment to seal the edges of the Supacolor.

  • Always test press on a spoiled or old cotton bag to dial in your press before pressing your production.
  • Supacolor always gives you spares so you can dial in your press.
  • Supacolor not sticking when you peel? Increase pressure and peel quickly within 2 seconds of lifting press, keep transfer a clear distance from seams and gussets.
  • Still won’t peel easily? Repress for 4 seconds then try from a different corner.
  • These instructions are your default starting point, settings may vary for different garments and presses.